Jenn-Air DW760, DW860 Leaves food soil on dishes, Leaves glassware cloudy or spotted, Seems noisy

Check these points if your dishwasher...

Leaves food soil on dishes

•Check to see that the water heater is set to delivera minimumof 120°F water at the fau- cet.

•Turn on hotwater at kitchensinkbefore run- ning the dishwasher to be certain that hot water is entering the first wash cycle.

•Models DW760 & DW860 Only - Select the AccuTempTM option.

•Checkwater hardness. Forextreme hardwater

conditions it may be necessary to install a mechanical water softener,

eUse the amount of detergent recommended for your water hardness, and be sure it is put in the dispenser as directed previously.

•Use fresh high phosphatedetergent that is not caked. Store detergent in cool, dry place.

•Select proper cycle for soil level of dish load.

•Be sure dishes are loaded properly with noth- ing blocking the path of the wash arms, center spray nozzle or detergent dispenser,

•Check for nesting of dishes that prevents water from reaching all surfaces.

•Check to make sure glasses are not loaded over prongs,

Leaves glassware cloudy or spotted

•Adjust the detergent amount to your water

hardness as described earlier in this book. Avoid overuse or underuse of detergent.

•Check to see that the water heater is set to deliver a minimum of 120°Fwater atthe faucet

nearest the dishwasher. Avoid extremely high or low temperatures.

•Use a rinse aid such as Jet-Dry.

•Do not pre-rinse dishes before loading them into the dishwasher.

e Refer to Water Conditions for more informa- tion. (See pp. 11-12.)

Does not dry properly

•Be sure the Heat Dry option is selected,

•Use a rinse aid.

•Check to see that the water heater is set to delivera minimum of 120°Fwater at the faucet nearestthe dishwasher. Run water and check temperature with a candy thermometer.

•Increase detergent use according to water hardness.

•Check for improperloadingand do not over- load. Dishesshouldnot nest together.

•Plasticitems have a poroussurfaceand tend to holdwater. Towel dryingmay be required.

•Glasses,cups,etc.,withconcavebottomswill hold water.

Stains or discolors dishes

•Aluminum utensils can leave markswhen they rub against other things. Load properly.

elrondeposits in the water can leave a yellow or brown film on dishes. You may desire to have aspecialfilterinstalledinthewatersupplyline, or periodically useRoVer Rust Remover. (See Water Conditions, pp. 11-12.)

Cycle takes too long

(Heating Delay light stays on)

•Model DW730 - The water temperature is too low and the dishwasher is automatically ex- tending the cycle to heat water to the proper temperature.

•Models DW760 & DW860 - The AccuTempTM option hasbeen selectedwhich willextend the cycle to heatwater thermostaticallywhen water temperature is low.

Clean light remains on

• Turn dial slightly clockwise until light shuts off.

Seems noisy

•Water circulation noise is normal.

•Humming during drain is normal.

•Dishes may not be loaded properly. Dishes should not be touching one another.

•Wash arm may be hitting an item when rotat- ing. Load items so nothing blocks the wash arm.

•Chopping or grinding noise may be heard during the cycle when the internal food dis- poser is chopping food.

•Detergent cup lid hits door liner when dish- washer door is opened at end of cycle and is normal.

•Installation (location, flooring, cabinetry, etc.) can affect noise level.

•Water valve hiss during fill is normal.

14