Jenn-Air ELECTRIC DOWNDRAFT SLIDE-IN RANGE Home Canning

13
Cooktop cartridges, either conventional coil or radiant
element, can be installed on either side of the range. (See
page 33 for all available cartridges and accessories, and their
model numbers.)
To Install Cartridges:
1. If the grill grates, element, and/or basin pan are in place,
remove before installing a cooktop cartridge. Clean
porcelain basin of any grease accumulation. (See page 8
for cleaning recommendations.)
2. To install any of the optional cooktop cartridges, be sure
controls are turned off and the cartridge is cool. Position
the cartridge terminal plug toward the terminal receptacle.
This receptacle is located at the front of the left side and at
the back of the right side of the range.
3. Slide the cartridge toward the receptacle until the
cartridge terminal plug is completely engaged.
4. Lower the opposite end of the cartridge into the rangetop
until it is flush with the surface. Your range is now ready
to use.
To Remove Cartridges:
1. Controls must be off and the cartridge should be cool.
2. Lift up the edge of the cartridge until top of cartridge
clears the opening on the range by about 2 inches.
Important: Lifting the cartridge too high while still
engaged in the receptacle could damage the terminal
plug.
3. To disengage terminal, hold cartridge by the sides and pull
away from the terminal receptacle. Lift out when fully
unplugged.
4. Do not stack cartridges where they may fall or be
damaged. Never store other materials on top of the glass-
ceramic cartridges since this could damage or scratch the
surface.
Home Canning
Canning should be done on the conventional coil cartridge
only. Canning element accessory, Model A145A, makes it
possible to use large oversized canners with the conventional
coil cartridge.
For additional information, refer to the Use and Care Guide
packaged with your cartridge.