Jenn-Air JGD8430 important safety instructions Using Your Cooktop

PORTS

USING YOUR COOKTOP

Surface Controls

CAUTION

•If flame should go out during a cooking operation, turn the burner off. If a strong gas odor is detected, open a window and wait five minutes before relighting the burner.

•Be sure all surface controls are set to the OFF position prior to supplying gas to the cooktop.

•NEVER touch cooktop until it has cooled. Expect some parts of the cooktop, especially around the burners, to become warm or hot during cooking. Use potholders to protect hands.

Surface Control
Knobs	i
		L
		o
Use to turn on the surface burners. An
	H
infinite choice of heat settings is available
from Lo to Hi. At the Hi setting a detent or
notch may be felt.

•A clicking (spark) sound will be heard and the burner will light. (All ignitors will spark when any surface burner knob is turned on. However, only the selected burner will light.)

Suggested Heat Settings

The size and type of cookware will affect the heat setting.

SETTINGS	USES
	Use Hi to bring liquid to a boil, or reach
Lo	pressure in a pressure cooker. Always
	reduce setting to a lower heat when
iH	liquids begin to boil or foods begin to
	cook.

An intermediate flame size is used to continue cooking. Food will not cook any faster when a higher flame setting is used than needed to maintain a gentle boil. Water boils at the same tempera- ture whether boiling gently or vigorously.

	Use Lo to simmer foods, keep foods
i	warm and melt chocolate or butter.
H

Pilotless Ignition

Pilotless ignition eliminates the need for a constant standing pilot light. Each surface burner has a spark ignitor. Use care when cleaning around the surface burner.

If the surface burner does not light, check if ignitor is broken, soiled or wet.

BURNER CAP

IGNIT OR

BURNER BASE

oL	Some cooking may take place on the
	Lo setting if the pan is covered. It is
	possible to reduce the heat by rotating
	the knob to the OFF position. Be sure
	flame is stable.

Flame-SensingTMRe-Ignition

Your cooktop has sealed gas burners with Flame-SensingTMRe-Ignition. If any burner flame should go out, the system will automatically spark to re-ignite the burner (all ignitors will spark when any flame is extinguished, however only the selected burner will reignite).

If intermittent sparking occurs, increase flame (rotate knob clockwise) until clicking (spark) sound ceases.

Setting the Controls

Your cooktop has sealed gas burners with automatic re-ignition. If the burner flame should go out, the system will automatically spark to re-ignite the burner.

1.Place a pan on the burner grate. (To preserve the grate finish, do not operate the burners without a pan on the grate to absorb the heat from the burner flame.)

2.Push in knob and turn immediately counterclockwise to the desired setting.

Operating During a

Power Failure

1.Hold a lighted match to the desired surface burner head.

2.Push in and turn the control knob slowly to the desired setting.

CAUTION

•When lighting the surface burners, be sure all of the controls are in the OFF position. Strike the match first and hold it in position before turning the knob.

•Do not leave the cooktop unattended when cooking during a power failure. The automatic re-ignition feature will not operate during a power failure.

5