Jenn-Air JRTDE228 Operation, Controls, Warm Cabinet Surfaces, Energy Saver Switch, is coldest

Operation

tt;	Controls		._
Your new refrigeratorhas two controls. One		9 is coldest [.	5 • [
for regulatingthe temperaturein thefreshfood
compartment and one for the freezer. The		Saves / %,ReduceEsxterior
freshfood compartmentand thefreezercorn-
parfmentcontrolsarelocatedat thetopfront of		Energy \ / _oisture
the fresh food compartment, Turn both con-		I._3
trois to "No. 5" to start your refrigerator.		u_i_t,l']I
The "No.g" freezer control setting is recom-
		I
mended for shortterm use only.		_	9 is coldest

Your refrigerator may run for several hours when you first start it. This is normal and shouldn'tbe causefor alarm.

Changingeither controlwill have someeffect onthe temperatureof the other compartment.

To start: Set fresh food control on "5".

In adayortwo,you maydecidethat one

or bothcompartmentsshouldbcontrol(s)e older

warmer. Ifso,adjustthe as instructedin the accompanyingchart.

IMPORTANT: Except when starting,

do not changeeither control morethan one number at a time. Allow 24 hours

for temperature to stabilize before re- setting.

Setfreezecontrolon "5".

Turn fresh food control to

Refrigerator tooWARM: nexthighernumber.

Refrigerator too COLD: Turn fresh food control to next lower number,

Turn treezef control to rtext

FreezertooWARM: hlFhernumber. Turnfreezercontrotol next

FreezertooCOLD: lowernumber.

Refrigerator OFF: Set fresh food control to OFF.

Warm Cabinet Surfaces

At times,the frontsurfaces of your refrigeratorcabinetmaybe warm to the touch. This is a normalfunctionof yourrefrigerator. This feature prevents moisturefrom condensingonth_ outsideof your refrigeratorduring humid weather. This condition may be noticeablewhen"-" you first start your refrigerator, during hot weather, and during excessive or lengthy door openings.

Energy Saver Switch

The Energy Saver switch controls a heater designed to prevent moisture accumulation betweenthe refrigeratorandfreezerdoorframe. Duringhumidweather,moisturecollectson objects that are cooler than the surrounding air. This condensation can be eliminatedby applying a small amountof heat to the surface uponwhich the water accumulates.

When the EnergySaver switchis on "SavesEnergy",no heat is appliedto the surface. Itis saving both energy and money. If humidity increasesand condensationappears, turn the EnergySaverswitchto "ReducesExteriorMoisture". Be sure toturn the EnergySaverswitch back to "Saves Energy" as the humidity drops to save energy.

In areas of relatively high humidity, the Energy Saver Switch in the "Reduces Exterior Moisture" position will minimize any collection of moisture on the outside surface of the cabinet.

8