3Com manual LCD Console, Switch 2000 TR banner

The LCD Console

The SuperStack II Switch 2000 TR has an LCD console located on the front panel. Use this console for read- ing and setting the Switch and module parameters.

Refer to the “SuperStack II Switch 2000 TR User Guide” for a menu map and for specific information and uses of the console.

The console provides a quick method for viewing the type of module in the Switch as well as the hardware and software versions of the module. See Figure 4-2.

The menus of the LCD module are circular. Press [Enter] until the menu you wish to view appears. For more information refer to Chapter 5 of the Switch 2000 TR User Guide that accompanies your switch.

To view the module status, proceed as follows from the top LCD menu which displays the

Switch 2000 TR banner:

Switch 2000 TR	ENTER	Module Type
			ENTER
> I/O Module		Module State
		HW Version

Figure 4-2I/O Module LCD Menus

The LCD Console 4-5

1Press [Enter] to view the next level.

2Press [Down Arrow] until

Switch 2000 TR > I/O Module appears.

3Press [Enter]. I/O Module > Module Type appears.

4Press [Enter]. STATUS > Module Type appears.

5Press [Down Arrow] to scroll down through the I/O Module menus.

6Press [Enter] at any one of the following fields to view the information described below. Press [Down Arrow] to move through the circular menus.

■Module Type—module type

■Module State—current state of module (UP, DOWN)

■HW Version—current version of hardware