5-2CHAPTER 5: CONFIGURING THE TR-IN-FE MODULE

Setting Up a Module

The Module Configuration Screen displays the set- tings used by the TR-in-FE Module to communicate with other devices on the network.

It is unlikely that you will need to change the value of these settings once they have been set.

CAUTION: If you need to change the value of any of the settings, you may experience a temporary loss of communication while the values are reset. If you do not need to make any changes, select the CANCEL button and not the OK button. Selecting the OK button resets the device.

To configure a module, log on to the Switch 2000 TR and proceed as follows:

1Select SWITCH MANAGEMENT from the Main Menu.

2Press [Space Bar] and select *I/O Module*.

The I/O Module screen appears. The I/O Module screen allows you to view statistics and set up the TR-in-FE module. See Figure 5-2.

If the I/O Module option does not respond, your TR-in-FE module is not installed correctly. Refer to Chapter 3 for information on installation.

3Enter the *Unit ID* of the unit with the module installed.

4Select SETUP.

Figure 5-2I/O Module Screen (CONFIG)

5Press [Return].

The Port Setup screen appears. See Figure 5-3.

Figure 5-3Port Setup Screen

Page 34
Image 34
3Com 2000 TR manual Setting Up a Module, 2I/O Module Screen Config