Move Refrigerator to Final Location
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not completely installed.
Keep doors taped closed until refrigerator is completely installed.
Use two or more people to move and install refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
■To avoid floor damage, make sure levelers are raised (not touching floor) and refrigerator is on rollers before moving.
■Use the installation block, attached to the door hinge, as a reference to make sure the refrigerator is pushed back far enough into the opening, so that when the panels are installed they will be flush with the adjacent cabinets.
NOTE: A flush installation is not possible with a 24" (60.9 cm) deep opening.
■After the refrigerator is leveled and aligned, remove the installation block from the door hinge and use it to check the spacing between the panels and adjacent cabinets.
NOTE: The installation block is designed to provide accurate spacing for ³⁄₄" (1.9 cm), ³⁄₈" (9.53 mm) and ¹⁄₈" (3.18 mm).
³⁄₄" | ¹⁄₈" | |
(1.9 cm) | ||
(3.18 mm) | ||
|
³⁄₈"
(9.53 mm)
1.Place top of cardboard carton or plywood under refrigerator. Remove dolly.
2.Move the refrigerator straight back and evenly into the opening. Be sure that the water tubing is not kinked and the power supply cord is on top of the refrigerator.
NOTE: If the power supply cord is behind the refrigerator, it will not install properly.
3.Make sure the installation block is flush with the adjacent cabinets.
NOTE: To achieve a flush installation, it is critical to verify a ³⁄₄" (1.9 cm) depth from the front face of the adjacent cabinetry to the refrigerator.
A 
B 
³⁄₄" (1.9 cm)
C
A. Adjacent cabinet or wall
B. Installation block
C. Face of refrigerator
Level and Align Refrigerator
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not completely installed.
Keep doors taped closed until refrigerator is completely installed.
Use two or more people to move and install refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT: All four leveling legs must contact the floor to support and stabilize the full weight of refrigerator. Rollers are for moving the refrigerator, not for permanent support.
After moving the refrigerator to its final location:
1.Use a ⁵⁄₁₆" socket driver to turn the leveling bolts clockwise to extend the legs to the floor as shown. The rollers should be off the floor.
A
A BB
A. Rear leveling bolt
B. Front leveling bolt
18
