Location Requirements |
|
|
| |
WARNING |
|
|
|
|
|
| 80" - 90" |
|
|
| B | |||
|
|
|
| |
|
|
|
| Dimension |
Explosion Hazard |
|
|
|
|
Keep flammable materials and vapors, such as |
|
|
|
|
gasoline, away from refrigerator. |
|
|
|
|
Failure to do so can result in death, explosion, or fire. | 84" (213.4 cm) |
|
| |
|
|
| ||
| to bottom of solid soffit |
| ||
IMPORTANT: |
|
|
|
|
■ Observe all governing codes and ordinances. |
|
|
|
|
■ It is recommended that you do not install the refrigerator near |
|
|
|
|
an oven, radiator, or other heat source. |
|
|
| 77" |
■ Do not install in a location where the temperature will fall |
|
|
| |
|
|
| (196 cm) | |
below 55°F (13°C). |
|
|
|
|
■ Floor must support the refrigerator weight, more than 600 lbs |
|
| A |
|
(272 kg), door panels and contents of the refrigerator. |
|
|
| |
■ Ceiling height must allow for side tipping radius. See “Tipping |
|
| Width |
|
| (see chart following) |
| ||
Radius.” |
|
|
|
|
■ Location should permit door to open fully. See “Door Swing |
|
|
|
|
Dimensions.” |
|
|
|
|
■ Location must permit top grille removal. See “Opening |
|
|
|
|
Dimensions.” |
|
|
|
|
Opening Dimensions |
|
|
|
|
■ The width of the opening, from side to side, must be as |
|
|
|
|
specified for your model, for at least 2" (5.08 cm) back from |
|
|
|
|
the face of the cabinet. |
| C | 1" |
|
|
|
|
| |
NOTE: If your opening does not meet this requirement, you | 6" |
| (2.54 cm) | 6" |
will need to make modifications. | (15.2 cm) |
|
| (15.2 cm) |
|
|
|
| |
■A solid soffit or wall cabinet must be installed 84" (213.4 cm) above the floor. If the solid soffit is higher than 84" (213.4 cm) or one is not available, then the refrigerator must be braced.
If the
■For a fully integrated installation, a minimum of 6" (15.24 cm) of open space above the refrigerator is required. See “Fully Integrated Installation.”
■A grounded 3 prong electrical outlet should be located within a specified number of inches from the
■The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor. See “Water Supply Requirements” for more information.
| Model | Width A (as shown |
| Dimension B (as |
|
| above) |
| shown above) |
|
|
|
|
|
| 42 | 42" (106.7 cm) |
| 10" (25.4 cm) |
| 48 | 48" (121.9 cm) |
| 16" (40.6 cm) |
|
|
|
|
|
|
|
| ||
| Installation Type | Depth C (as shown above) | ||
|
|
| ||
| Standard Flush | 25" (63.5 cm) minimum | ||
| (new installation) |
|
| |
|
|
| ||
| Retrofit Installations | 24" (60.9 cm) minimum | ||
|
|
|
|
|
IMPORTANT:
■The width of the opening (Width A), must be as specified for your model, for at least 2" (5.08 cm) back from the face of the cabinet.
NOTE: If your opening does not meet this requirement, you will need to make modifications.
■Flooring under refrigerator must be at same level as the room. Face of cabinetry must be plumb.
7
