Jenn-Air WM227 Other, Caring, Cleaning, Surfaces, of Your, Oven Racks, Oven Light Bulb

	Other		Hints	on	Oven
	Caring		for	Your
Cleaning	Other	Surfaces		of Your	Oven
Door and	control panel	trim:	The metal	trim around	the door and the control

panel can be cleaned with any nonabrasive cleansers such as Bon-Ami or soapy water; rinse

well. Be careful not

to use an excessive amount

of water.

Glass

on

the

control

panel

front

and

oven

door

front:

To

clean,

use

any suitable

glass cleaner

or soapy water. To

prevent

moisture from getting behind the glass

control

panel,

spray

a cloth

with glass

cleaner then

wipe

the panel.

Control

Knobs:

The

knobs on

the control

panel can

be removed with

the

controls

in

the OFF position. Pull	each	knob	straight	from	the shaft.	Wash knobs in warm soapy water
or dishwasher; do not	use abrasive		cleansers or		materials.	To replace each knob, match flat
part of knob opening with the		spring	on the	shaft,	returning	in OFF position.

Oven Racks

To remove, pull forward to the "stop" position, lift up on the front of the rack and pull out.

Oven Light Bulb

Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker panel. Be sure that the entire oven cavity including the light bulb is cool before attempting to remove.

To replace light bulb:

1.Carefully remove the glass light lens and lens retainer by removing the two screws in the light lens retainer using a phillips screwdriver. Note: The light lens is separate from the light lens retainer. The two pieces will drop down into your hands at the same time. Oo NOT remove the remaining two screws.

2.To obtain firm grasp on bulb, wear protective rubber

gloves. Remove by turning bulb to the left. Do not touch a hot oven light bulb with a damp cloth as bulb will break. Note: If the bulb does break and you wish to remove it, be certain power supply is disconnected and wear protective gloves. You may contact your authorized Jenn- Air Service Contractor for service.

3.Replace bulb with a 40 watt oven-rated appliance bulb.

Bulb with brass base is recommended to prevent fusing of bulb into socket.

4.Place light lens inside of light lens retainer. Holding the light lens and lens retainer in place, insert the two screws into the light lens retainer and tighten.

28