HD5313

Menu Operation

Press and hold the rotary encoder (4) to access the system menu. Repeatedly press the rotary encoder button to access menu options in the following order:

BEEP ON/OFF: The beep tone feature allows the selection of an audible beep tone to be heard each time a button is pressed on the face of the radio. “BEEP ON” is the default display. Turn the rotary encoder to select the “BEEP OFF” option.

P--VOL: Turn the rotary encoder to select the default volume the radio will assume when first turned on.

PCLK ON/OFF: When “ON”, the clock and backlight will remain on when the unit is turned off.

HOURS 12/24: This option allows selection of a 12 hour or 24 hour clock format. “HOURS 12” is the default setting. Turn the rotary encoder to change to the 24 hour clock format.

DIMMER: Turn the rotary encoder to change the LCD backlight brightness from HIGH (default) to MIDDLE to LOW.

LOCAL/DX (distant): If the stereo signal is intermittent, you can select “LOCAL” to access only strong local stations. “DX” is the default setting.

Equalizer

Press the EQ button (20) to choose one of the following pre-defined bass and treble curves: POP > JAZZ > CLAS > BEAT > ROCK > OFF.

Loudness

Press and hold the BAND button (3) toggle loudness on/off. When listening to music at low volumes, this feature will boost the bass and treble ranges to compensate for the characteristics of human hearing.

Auxiliary Input

To access an auxiliary device:

1.Connect the portable audio player to the AUX IN jack on the front panel (12).

2.Press the SRC button (2) to select AUX mode.

3.Press SRC again to cancel AUX mode and go to the next mode.

Setting the Clock

If not already showing, press the DISP button (7) to display the clock. With the clock displayed, press and hold the DISP button and the time will flash on the display. Press the >> button (10) to adjust the hours or the << button (11) to adjust the minutes. When in “HOURS 12” mode, “AM” or “PM” will appear on the display to indicate AM or PM. When no adjustment is

made for five seconds, the time will become set and normal operation will resume.

Reset Button

The RESET button is located behind the front panel and should be activated for the following reasons:

initial installation of the unit when all wiring is completed

function buttons do not operate

error symbol on the display

Use a ball point pen or thin metal object to press the RESET button. This may be necessary should the unit display an error code.

4

Page 8
Image 8
Jensen HD5313IR operation manual Menu Operation, Equalizer, Loudness, Auxiliary Input, Reset Button