GETTING STARTED
Clock Back-up Battery Installation
1.Remove the screw from the BATTERY COMPARTMENT COVER and remove the cover.
2.Install a CR2032 lithium battery (not included) in the battery compartment following the polarity markings shown on it.
3.Replace the BATTERY COMPARTMENT COVER and tighten the screw to secure the
compartment.
Note: The unit will still operate without the battery installed, but the time, alarm and radio preset settings will be lost and have to be reset in the event of a power interruption or failure.
WARNING:
Be sure that the battery is installed correctly. Wrong polarity may damage the unit. If the unit is not to be used for an extended period of time, remove the battery. Any old or leaking battery can cause damage to the unit and may void the warranty.
Do not dispose of battery in fire, battery may explode or leak.
Do not try to recharge a battery that is not intended to be recharged; the battery can overheat, rupture and leak (Follow the battery manufacturer’s directions).
AC-DC Adaptor Connection
An
1.Firmly and securely insert the DC plug of the adaptor to the DC jack on the back of the unit.
2.Plug the adaptor’s AC plugs into an AC outlet.
NOTE: This unit is not magnetically shielded and may cause color distortion on the screen of some TVs or video monitors. To avoid this, you may need to move the unit further away from the TV or monitor if unnatural color shifts or image distortion occurs.
CLOCK SETTING
TO SET THE TIME USING iPhone / iPod TIME SYNC
After plugging in the AC adaptor power, “12:00” will appear and start blinking in the LCD Panel. If you have an iPod or iPhone with the correct time showing, you can dock it securely into the Docking Bay to take advantage of Automatic Time Sync.
Note: older iPod models such as iPod mini do not support this feature.
1.When “12:00” is flashing on the LCD Display after the initial power connection, insert your iPod/iPhone onto the connector in the docking bay.
0
