Canister Installation – DC-650C/CRC
1.Place the canister filter so that it fits snugly over the housing and tighten the four knobs (A, Fig. 7).
2.Mount handle (B, Fig. 7) to the arm (C, Fig. 7) with a M8 flat washer (D, Fig. 7), M8 lock washer (E, Fig. 7), and a M8 hex nut (F, Fig. 7).
3.Thread a M10 hex nut (G, Fig. 7) onto the threaded rod found on top of the canister filter followed by a M10 lock washer (H, Fig. 7), and M10 flat washer (I, Fig. 7).
4.Mount the arm (C, Fig. 7) to the threaded rod on top of canister with one M10 flat washer (J, Fig. 7), and a M10 hex nut (K, Fig.7).
Collector Bag Installation – DC-650C/CRC
1.Place snap ring (K, Fig. 8) over the top of plastic bag (L, Fig. 8) and fold over the bag approximately three inches.
2.Insert the snap ring of the collector bag into the bottom of the housing at an angle, see Figure 9.
3.Pull down on the ring to make sure it “seats” in the housing.
Note: make sure the snap ring “snaps” into place in the housing, and also that the plastic bag hangs down approximately 3” so that there are no air leaks.
Figure 7
Figure 8
Figure 9
10
