Prior to Operation
1.Check to see that the blade tooth direction matches the diagram on saw body.
2.Check to see that the blade is properly seated on the wheels after proper tension has been applied.
3.Set the blade guide roller bearings snug against
blade. See "Adjusting Blade Guide Bearings"for more detail.
4.Check for a slight clearance between the back up rollers and the back of the blade.
5.Position both blade guides as close to work as possible.
6.Select proper speed and feed rate for material being cut. See the enclosed "Lenox Guide to Bandsawing" for further information.
7.Material to be cut must be held securely in vise.
8.Check to see that coolant level is adequate.
9.Do not start a cut on a sharp edge.
1O. Keep the machine lubricated. See the "Lubrication" section.
Changing Blade Speed
1. Disconnect the machine from the power source.
2. Loosen the motor plate lock bolt (A, Fig. 7).
3. Loosen motor plate slide bolt (B, Fig. 7) until the belt can be moved on the the pulleys.
4. Move the belt to the the desired pulley combination.
5. Tighten the motor plate slide bolt (B, Fig. 7) to
Fig.7
6.Tighten the motor plate lock bolt (A).
7.Connect the machine to the power source.
6
