Jet Tools J-3410, J-3410-2

Figure 8: Placing workpieces in the vise

Contents

Main Warranty and Service 90 1 LIFE 5 LIFE Table of Contents General Specifications Specifications: Machinery general safety warnings ABCD Conductor length AWG (American wire gauge) number Safety instructions on sawing systems Operating Instructions Using the vise Figure 1: Vise jaw nomenclature Locking vise jaw Changing the locking jaw location: Stationary vise jaw Changing the stationary vise jaw position: Adjusting stationary jaw: straight cuts Adjusting stationary jaw: angle cuts Adjusting stationary jaw for high accuracy angle cutting: Adjusting angles with the scale on the saw table Setting the blade guides Controlling the cut: Hydraulic feed control Using the stock stop for repeated cuts Changing blade speeds To change blade speeds: Gearbox Motor Blade selection Right angle cuts -- single pieces of stock Angle cutting Table 1: Suggested cutting speeds Page Maintenance Replacing blades Adjusting blade tracking To adjust blade tracking: Blade alignment adjustments When to adjust the blade guides Replacing blade guide and support components Adjust blade for parallelism: Adjusting blade vertical: Test cutting to verify adjustment accuracy Adjusting guide bearings Replacing guide bearings Adjusting blade back-up bearings Replacing the drive wheel Replacing idler wheel or bearings Installing the vertical sawing table Servicing the hydraulic control cylinder Machine Set-up Uncrating and spotting the saw Electrical To change the operating voltage Figure-20 Installing the coolant kit Chip brush replacement Adjusting the horizontal stop and motor switch To replace or adjust the hori- zontal stop: Adjusting the motor switch actuator Troubleshooting Problem Probable cause Potential solutions Page Replacement Parts Page Parts List - Saw Head Page Parts List - Saw Base Ref. no. Part no. Description Qty. Ref. no. Part no. Description Qty. Parts List - Hydraulic Cylinder