Jet Tools JDP-12 operating instructions Introduction Specifications

Introduction

This manual is provided by JET covering the safe operation and maintenance procedures for the JET JDP-12 Drill Press with Digital Readout. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or JET. JET can also be reached at our web site: www.jettools.com.

Specifications

Model Number	JDP-12
Stock Number	707300
Swing	12”
Type	Bench Top
Drilling Capacity	5/8”
Chuck Size	5/8”
Spindle Travel	3-1/8”
Spindle Distance to Base	23-1/2"
Spindle Distance to Table (max.)	17”
Table Size Diameter (width x depth)	9-1/2" x 9-1/2"
Table Tilt	+ or - 45°
Spindle Taper	MT-2
Column Diameter	2-1/2"
Number of Spindle Speeds	Variable
Range of Spindle Speeds	530-3000 RPM
Light Bulb	40W max.
Overall Height	37"
Base Size	11-1/2" x 16-1/2"
Motor	115V only, 1/3HP, 1 Ph, 5A
Net Weight (approx.)	88 lb.
Shipping Weight (approx.)	93 lb.

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.

Read and understand the entire contents of this manual before attempting assembly or operation! Failure to comply may cause serious injury!

6