Assembly
Base and Column Assembly
Referring to Figure 1:
1.Place the base (D) on a level floor.
2.Place the column assembly (E) on the base (D) and align the holes in the column support with the holes in the base.
3.Using a
Table and Rack
Referring to Figure 2:
When shipped, the rack ring (E1) and rack (E3) are bundled together with the column (E) in plastic wrap.
1.Remove the wrap and take the rack ring (E1) and rack (E3) off the column (E). Note which end of the rack is up. It must be reinstalled later with the same side up.
2.Place the rack (E3) inside the table bracket (C) such that the teeth of the rack (E3) mesh with the pinion gear on the end of the table crank handle shaft (C1).
3.Slide the bracket assembly (C) together with the rack (E3) onto the column (E) as shown.
4.Place the rack ring (E1) onto the column (E), sliding it down so it rests against the rack (E3) as shown and tighten the setscrew (E2) with a 3mm hex wrench (provided).
5.Place the table (B) onto the table bracket (C), positioning it as shown in Figure 2. Secure table with table lock handle (L).
6.Secure the table extension (B1) with two table extension lock knobs (Q).
Table Height Adjust and Column Lock Handles
Referring to Figure 2:
1.Loosen the setscrew (R1) on the table height adjust handle (R).
2.Slide the handle (R) onto the table bracket shaft (C1).
3.Turn the handle (R) until the setscrew (R1) is on the flat section of the shaft (C1) and tighten the setscrew (R1) with a 3mm hex wrench to secure the handle.
4.Thread the column lock handle (K) into the back side of the table bracket (C) opposite the height adjust handle (R).
Figure 1
Figure 2
8
