12
Canister Filter (optional accessory)
1. Remove the inlet port that came with the
sander.
2. Mount the plastic elbow (A, Fig. 9) to the
sander using the same hardware (B, Fig. 9)
from t he inlet port.
3. Connect the filter (C, Fig. 9) to the elbow
and turn count er-cl ock wise so that it l ocks in
place.
WARNING
Static electricity will build up in the filter
during operation. The filter ground must be
attached to the machine ground, and to the
filter. Failure to comply may result in
fire/loss of property, or personal injury!
4. Remove the screw (D, Fig. 9) from the
sander base. Attach the end of the
groundi ng wi re to the screw and thread bac k
in to the base.
5. Attach the grounding clip (E, Fig. 9) to the
metal part of the filter. This will prevent
static electricity from buil ding up in the filt er .
Cleaning the Filter
CAUTION
Wearin g a part icle mask/respirato r f or
protection against fine dust particles during
cleaning is highly recommended.
Clean the canister filter frequently to keep the
sander’s perf or manc e at i ts opti mum. To c lean:
1. Disconnect the machine from the power
source.
2. Take of f the grounding clip and remov e the
fi lt er (C, Fi g. 9) by turning clockwise.
3. Empty the contents into an appropriate
container.
4. The filter can be cleaned with a low
pressure air hose. Blow f rom t he outside of
the filter to clean the dust particles. For
best results check and empty the filter
frequent ly .
5. Install the filter and reattach the grounding
clip.
Optional Accessories
708438: O pen Stand
708434: Canister Fi lt er
57620025: JE T St ik A brasive Belt and Disc
Cleaner.
Dust Collecto rs and A c c essories see a JET
Distributor.
JDS-12B Sanding Disc PSA Aluminum Oxide
“J” Weight Clot h B ac k .
12” 36 Grit 50 Grit 60 Grit
Stock
Number 57698525 57698650 57698750
Master
Carton 25 50 50
12” 80 Grit 100 Grit 120 Grit
Stock
Number 57698850 57698950 57699050
Master
Carton 50 50 50