Jet Tools JWCS-10A owner manual Table Insert Adjustment, Blade Raising and Tilting Mechanism

Table Insert Adjustment

•Hardware: Table Insert

•Tools: 3mm Hex Wrench, Straight Edge

1.Lower blade completely.

2.Place the open end of the insert under the splitter and lower the insert into the opening.

3.Adjust the table insert flush with the table by turning four leveling screws (A, Fig. 9) and using a straight edge.

Mounting Rails & Extension Table

With the extension wing properly aligned, the rail and fence assembly can now be mounted to the saw. See the Owner’s Manual for the XACTA Fence Assembly Instructions. This will address the mounting of the table, switch, rails and fence.

Miter Gauge Operation

•Hardware: Miter Gauge

•Tools: Cross Point Screwdriver, 8mm Wrench

1.Adjust miter gauge by loosening lock knob (A, Fig. 10) and turning miter body to desired angle. To move gauge beyond index stops, flip down the stop (B, Fig. 10).

2.Adjust index stops by turning one of three adjustment screws (C, Fig. 10).

Note: Always make test cuts. Do not relay solely on miter gauge indicator marks. There are two holes in the miter gauge body that will allow you to mount an wooden extension face.

Blade Raising and Tilting Mechanism

CAUTION

Never try to force the tilting mechanism past the 45° or 90° stops! This may cause the blade to go out of alignment!

1.To raise or lower the saw blade, loosen lock knob (A, Fig. 11), and turn handwheel (B, Fig. 11) until desired height is reached. Tighten lock knob. The blade should be adjusted about 1/8" above the top surface of the material being cut.

2.To tilt the saw blade, loosen lock knob, turn handwheel (C, Fig. 11) until desired angle is obtained, then tighten lock knob.

11