9
HandWheel Assembly• Hardware: (2)Handl es,(2) Hand W heels& (2)
Lock Knobs
• Tool: 14mm Wrench
1. Attachhandle (A, F ig. 4) to hand wheel (B,
Fig. 4).
2. Attachhand wheel assembly to saw with
lockknob (C, Fig. 4).
3. Makesure the pin(D, Fi g,4)aligns with the
notch in the hand wheel. Repeat for second
hand wheel.
Blade Guard Assembly• Hardware: (1)Blade G uard Assembly, (1)
Blade Guard Post (1) M16 Nut & Lock Washer &
(3) M10 Flat Washers
• Tools: 13mm Wrench, 3mm Hex Wrench and a
Cross Point Screwdriver
1. Threada M16 hex nut and M16 Lock
Washer (A, Fig. 5) completely onto t he
blade guard post (B, Fig. 5).
2. Threadblade guard post into t runnion at the
rear of the saw, (Figure 5). Tighten by
placing a cross point screw driver through
the hole at the end of the post and turning
clockwise.
3. Slidelower blade guard brac ket (A, Fig. 6)
onto blade guard post and tighten set
screws (B, Fig. 6) just enough to hold the
bracket in place.
4. Attachupper blade guard brack et (C, Fig. 6)
to lower blade guard bracket with two hex
cap bolts, four flat washers, two lock
washersand twohex nuts (D, Fig.6). Hand
tighten only at this tim e.