3
WARNING
1. Readand understand the entire
instruction manual before attempti ng
assembly or operation.
2. This table saw is designed and intended
for use by properly trained and
experienced personnel only. If you are
not familiarwith the proper and safe
operationof a table saw, do not use until
propertraining and knowledge have
been obtained.
3. Always wear approved safety glasses/face
shields while using this machine.
4. Make certain the machine is properly
grounded.
5. Before operating the machine, remov e tie,
rings, watches, other jewelry, and roll up
sleeves above the elbows. Remove al l
loose clothing and confine long hair. Donot
wear gloves.
6. Keep the floor around the machine clean
and free of scrap material, oil and grease.
7. Keep machine guards in place at all tim es
when the machine is in use. If remov ed for
maintenance purposes, use extreme caution
and replace the guards immediately.
8. Do not over reach. Maintain a balanced
stance at all times so that you do not fall or
lean against blades or other moving parts.
9. Make all machine adjustments or
maintenance with the machine unplugged
from the power source.
10. Use the right tool. Don'tforce a tool or
attachment to do a job that it was not
designed for.
11. Replace warning labels if they become
obscured or removed.
12. Make certain the switch i si n the OFF
position before connecting the machine t o
the power supply.
13. Give your work undivided attention.
Looking around, carrying on a conversation,
and "horse-play" are careless acts that can
resultin serious injury.
14. Keep visit orsa saf e distance from the work
area.
15. Use recommended accessories; im proper
accessories may be hazardous.
16. Never place hands dir ectly in line with the
sawbl ade.
17. Always use push sticks when cutting small
material.
18. Raise or lower the blade only when the
machine has been turned off and the blade
has come to a complete stop.
19. Read and understand warnings posted on
the machine.
20. Use blade guard for ev ery applicable
operation including all through cuts. If
guard is removed for special non-through
cuts such as dado and rabbet cuts, replace
before further use of the saw.
21. Failure to com ply with all of these warnings
may cause serious injury.
22. Some dust created by power sanding,
sawing,grinding, drillingand other
construction activiti es contains chemicals
known to cause cancer, birth defects or
other reproductive harm. Som e examples
of these chemicals are:
• Lead from lead based paint
• crystallinesilica from bricks and cement and
other masonry products, and
• arsenic and chromium from chemi cally-
treated lumber.
23. Your risk f rom those exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventil ated area,
and work with approved safety equipment,
such as those dust masks that are
specifically designed to fil ter out
microscopic particles
24. Do not operate tool while under the
influence of drugs, alcohol or any
medication.