8.Align holes on bed with those in the stand top and fasten with eight hex socket cap screws (5/16"x1") , eight lock washers (5/16"), and eight nuts (5/16") supplied. Note: Two larger
hex socket cap screws and washers will be used later to attach the bed extension to the
bed.
9.Tighten eight hex socket cap screws with a hex wrench.
1O. Tighten all stand hardware making sure it is stable on the shop floor.
11.Attach bed extension to bed using two hex socket cap screws (3/8"x1") and two lock washers (3/8") supplied.
12.Insert index plunger (A, Fig. 2) into the base of the headstock (B, Fig. 2) and tighten.
13.\ttach the headstock lock handle (A, Fig. 3) to the head stock lock shaft (B, Fig. 3) with one spring (C, Fig. 3) and one hex socket cap screw (0, Fig. 3).
14.Attach the tailstock handleto the to the tailstock handwheel and tighten.
15.Connect the motor cord plug to the switch plug.
Controls
Speed Selector (A, Fig. 4) - selects one of six available speeds. Select desired speed by pulling handle out from headstock and turning to left or right. Release handle and it will engage detent for that speed. Caution: Never change speeds without
motor running. Damage to the variable speed pulleys may result.
Headstock Lock (B, Fig. 4)
Detent Release (C, Fig. 4) - pull out and hold to swivel headstock. Release to engage detents at 90 or 180 degrees.
..- _. ..~- - ~_. | ,,- |
~A
B -~c --' ~D--
FIG-3
FIG-4
6
