5.0 Specifications
Model number |
| |
Stock numbers: |
|
|
Lathe with Leg Set | 719400K | |
Lathe only | 719400 | |
Leg Set only | 719402 | |
Bed Extension 20”, with tool post (optional accessory) | 719401 | |
Motor and electricals: |
|
|
Motor type | totally enclosed fan cooled, induction, capacitor start | |
Horsepower | 1HP (0.746 kW) | |
Phase | single | |
Voltage | 115/230V (prewired 115V) | |
Cycle | 60Hz | |
Listed FLA (full load amps 115V/230V) | 11/5.5 A | |
Starting amps | 10 A | |
Running amps (no load) | 6.6 A | |
Start capacitor | 200MFD, 125VAC | |
Run capacitor | 30μF, 250VAC | |
Power transfer | ||
Variable drive | Reeves Drive, with variable speed within established range | |
On/off switch | toggle switch with removable safety key | |
Motor speed | 1720 RPM | |
Power cord | 3/C 16 AWG (300V) | |
Power cord length | 6 ft. (183cm) | |
Power plug installed (115V) | ||
Power requirements | single phase | |
Recommended circuit and fuse/breaker size1 | 20A (115V), or 15A (230V) | |
1 subject to local/national electrical codes. |
|
|
Capacities: |
|
|
Working distance between centers | 40” (1016mm) | |
Working distance between centers, optional 20” bed ext. mounted | ||
Maximum distance between spindle face and tailstock quill, optional 20” bed ext. mounted | ||
Swing over bed | ||
Swing over tool rest base | 11” (280mm) | |
Number of indexing positions | positive locking, 10 degree increments | |
Swing over 20” bed extension in low position (optional accessory) | ||
Headstock and Spindle: |
|
|
Spindle taper | #2 Morse | |
Spindle thread size | 1” x 8 TPI | |
Spindle speed (RPM) | variable within 400 to 3000 | |
Headstock spindle bore | 3/8” (10mm) | |
Spindle direction | forward | |
Headstock movement | sliding and 360 deg. rotation | |
Headstock rotation positive lock positions | 0, 30, 60, 90, 120, 180, 270 deg. | |
Tailstock: |
|
|
Tailstock quill taper | #2 Morse | |
Tailstock bore | 5/16” (9mm) | |
Tailstock quill travel | ||
Tailstock quill thread | acme, | |
Materials: |
|
|
Legs | cast iron | |
Bed | cast iron | |
Headstock | cast iron | |
Tailstock | cast iron | |
Tailstock quill | hardened HRC20 steel, with laser etched scale | |
Tool support and base | cast iron | |
6
