S T E P 4
Looking from under the hood take note of the location of the relay that is screwed to the cross channel. inside that channel on the bottom there is a hole that should line up with the threaded insert in the top of the Stealthbox®, this hole needs to be enlarged (see DETAILS below)
S T E P 6
Install the included Custom Aluminum Bracket on the drivers side of the subwoofer enclosure as shown using the supplied
Relay Screw
Enlarged Hole
D e t a i l
This DETAIL at left, shows a view looking down into the
D E T A I L
Enlarge the hole in the
*CAUTION*
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.
HEX BOLT |
|
| LOCK WASHER |
| FLAT WASHER |
| 1/2”ALUMINUM SPACER |
| |
THREADED INSERT | STEALTHBOX WALL |
|
D e t a i l
This is how the hardware should be arranged in the channel then, threaded into the top of the enclosure. (as mentioned at far left)
S T E P 7
Sliding the enclosure back into place, make sure that the wire is not pinched or damaged and align the top threaded insert with the hole enlarged in STEP 4. Start the hardware as mentioned before into the threaded insert. Also align the Custom Aluminum Bracket and the Square
S T E P 5
Set the Square
S T E P 8
Once all of the hardware is started, tighten all of the fasten- ers, rotating from each nut to another like you were chang- ing a tire.
Page 2 • JL Audio, Inc 2008 | Continued on Next Page |