4 “Automatic Dry” button

This button allows you to choose the required degree of drying for cottons and synthetics:

-Extra dry (only for cottons)

-Cupboard dry (cottons and synthetics)

-Iron dry (only for cottons)

The drying time is automatically adjusted by the machine: the laundry will be dried to the selected degree of dryness.

5 “Time dry” button

If you wish to carry out a timed programme instead of an electronic programme push this button until the drying time you want appears in the display according to the fabrics (cotton or synthetics) you have to dry.

For Cottons you can select a drying time from 10 minutes to 200 minutes .

For Synthetics you can select a drying time from 10 minutes to 130 minutes.

Options

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before pressing the “Start/Pause” button.

When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out.

If an incorrect option is selected, the red pilot light of the Start/Pause button flashes for a few seconds and the message Err is displayed.

6 “Prewash” button

Select this option if you wish your laundry to be prewashed at 30°C max. before the main wash (not available for Wool, “45 Minute wash” and “14 Minute wash”).

The prewash cycle ends with a short spin at 650 rpm in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. This option can be selected for heavily soiled laundry.

7 “Extra rinse” button

This option can be selected with all programmes, except Wool and “14 Minute wash”. The machine adds 2 rinses for cotton and 1 rinse for synthetics and delicates.

This option is recommended for people who are allergic to detergents, and areas where the water is very soft.

8 “Start/Pause” button

This button has two functions:

Start: after you have selected the desired programme and options, press this button to start the washer- dryer. The green light of the button will stop flashing and remain lit.

If you have selected a delay time, the countdown will begin and will be shown on the display.

Pause: when you press this button again, the programme in progress is interrupted. The light of the button will start flashing. To restart the programme from the point at which it was interrupted, press the button again.

Important!

You must set the washer-dryer to Pause before you make any change in the programme in progress.

9 Door lock light

After you have started the programme, the Door lock light illuminates to indicate that the machine starts working and the door is locked.

This light is also on during the countdown of the delay start.

This light indicates if the door can be opened:

light on: the door cannot be opened.

The appliance is operating or there is water left in the tub. Attention! If the door is locked do not try to open or force it!

light off: the door can be opened. The washing programme has finished.

10 “Delay start” button

This button enables you to delay the starting of the programme for 30 min - 60 min - 90 min, 2 hours and then by 1 hour increments up to a maximum of 20 hours. The delay you have selected is shown on the display for about a few seconds; afterwards, the duration of the programme reappears.

You must select this option after you have set the programme and before you press the “Start/Pause” button.

13

Page 13
Image 13
John Lewis 1609 Automatic Dry button, Time dry button, Options, Prewash button, Extra rinse button, Start/Pause button