Installing the cooker hood
Fitting the wall brackets
•Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed.
•Draw a horizontal line at 850 mm above the hob.
•Mark a point (1) on the horizontal line, 250 mm to the right of the vertical reference line.
•Repeat this operation on the other side, checking that the two marks are level.
•Mark a reference point (2) as indicated at 200 mm from the vertical reference line and 540 mm above the hob.
•Repeat this operation on the other side, checking that the two marks are level.
•Drill at the points (1) marked, using a ø 12 mm drill
bit.
• Drill at the points (2) marked, using a ø 8 mm drill bit.
•Insert the bracket plugs 11a into the holes 1 and screw into place.
•Insert the wall plugs 11 in the holes. 2.
Note: If the hood is to be installed onto a hollow construction or plaster or partition board wall then special fixing screws will be required (not supplied).
���
���
��
���
��� ���
� | � |
��� | ��� | ��� |
|
| |
� |
| � |
|
| ��� |
Fitting the canopy hood
•Disconnect by pulling only the central ducting panels.
•Remove the metal grease filters (see Maintenance para- graph)
•Adjust the two screws Vr, on brackets 11a, to a mini- mum.
•Hook the hood canopy onto the two brackets 11a.
•From inside the hood canopy, adjust the screws Vr to set the Hood Canopy level.
•Tighten the safety screw 12a.
���
��
6
