í
8
Connecting The Appliance To
The Power Supply
• The electrical outlet should be readily accessible so
that the unit can be unplugged easily in an
emergency.
• The socket should not be positioned behind the
cupboard.
• The best position is above the cupboard, see (A).
• If connection is to be made to position (A), remove the clip
from position 15 on the rear of the oven and use the clip to
secure the power supply cord to the top of the housing unit.
When not connecting the power supply cord to position
(A), the power supply cord should be routed under the
oven.
• Connect the appliance to a single phase 230-240V/50Hz
alternating current via a correctly installe d earth socket. The
socket must be fused with a 16A fuse.
• If the appliance is to be operated in a non-European
country, the supply voltage, current type and
frequency of the appliance indicated on t he rating
plate must correspond with the specificat ion of your
power supply. The rating plate can be found o n the
inside face of the control panel.
• The power supply cord may only be replaced by an
electrician.
• Before installing, tie a piece of string to the power supply
cord to facilitate connection to point (A) when the appliance
is being installed.
• When inserting the appliance into the high-sided cupboard,
DO NOT crush the power supply cord.
(A)
Electrical Connections
• If the plug that is fitted to your appliance is not suitable for
your socket outlet, it must be cut off and the appropriate
plug fitted.
• Remove the fuse from the cut off plug. The cut off plug
should then be disposed of to prevent the hazard of shocks
in case it should be plugged into a 13 Amp socket in another
part of your home.
Important:
The wires in the mains lead are coloured in accordance with the
following code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
If you fit your own plug, the colours of the wires in the mains
lead of your appliance may not correspond with the markings
identifying the terminals in your plug, proceed as follows:
• Connect the green and yellow (earth) wire to the terminal in
the plug which is marked with the letter ”E” or the earth
symbol ( ) or coloured green and yellow.
• Connect the blue (neutral) wire to the terminal in the plug
which is marked with the letter ”N” or coloured black.
• Connect the brown (live) wire to the terminal in the plug
which is marked with the letter ”L” or coloured red.
13 AMP
GREEN & YELLOW 13 AMP FUSE
BROWN
CORD CLAMP
BLUE
WARNING:
THIS APPLIANCE MUST BE EARTHED The
manufacturer declines any liability sh ould this safety
measure not be observed.