| Residue inside the drum. | Clean the drum inside. | |
|
|
| |
| High water hardness. | Set suitable water hardness4). | |
Loading door |
| Install fine filter and/or snap course filter | |
does not | Filters not locked in place. | ||
into place. | |||
close |
| ||
|
| ||
|
|
| |
Err (Error) on | Attempt to change parameters after start | Turn the dryer off and on. Set requested | |
the LCD. | of the programme. | parameters. | |
|
|
| |
No drum | Programme selector in Off position. | Turn it to any programme. | |
light | Defective light bulb. | Replace light bulb (see next section). | |
|
|
| |
Abnormally | Time to end is calculated on the basis of: | Automatic process; this is not a machine | |
elapsing time | |||
type, volume and dampness of laundry. | fault. | ||
on LCD | |||
|
| ||
|
|
| |
Programme | Full water reservoir. | Empty water reservoir3) , press Start/ | |
inactive | Pause button. | ||
| |||
|
|
| |
Drying cycle | Small laundry volume./Too dry laundry | Select time programme or higher drying | |
to short | for selected programme. | level (e.g. Extra dry ). | |
|
|
| |
| Fluff filters clogged. | Clean fluff filters. | |
|
|
| |
Drying cycle | To high loading volume. | Respect max. loading volume. | |
|
| ||
Laundry insufficiently spun. | Spun adequately the laundry. | ||
to long 5) | |||
| Particularly high room temperature - no | Lower the room temperature if possible. | |
| machine fault. | ||
|
| ||
|
|
|
1)In case of error message on the LCD (e.g. E51): Switch the dryer off and on. Set programme. Press the Start/ Pause button. Does not work? - inform local service and quote the error code.
2)follow program recommendation - see Programme chart chapter
3)see Maintenance and cleaningchapter
4)see Machine settings chapter
5)Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Replacing the drum light
Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local Service Force Centre.
Important! When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.
Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!
Warning! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.
1.Unscrew the cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)
22
