John Lewis JLTDH15 Machine settings, Alarm permanent on/off, Adjusting the level of conductivity

2.Replace the defective bulb.

3.Screw cover back down.

Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing o-ring gasket on door light cover.

Warning! For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Machine settings

Alarm permanent on/off

The alarm is by default always off. To set permanent alarm on (off):

1.Turn the programme selector to any programme.

2.Press simultaneously the Intensive and Anti-creasebuttons and hold down for approx. 5 seconds.

Adjusting the level of conductivity

Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values.

Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water.

In order to establish the conductivity of the water in your area please contact your water board.

1.Turn the programme selector to any programme.

2.Press simultaneously the Anti-creaseand Start/Pause buttons and hold down for approx. 5 seconds.

3.Press the Start/Pause button until you set desired level:

low conductivity <300 µS/cm

medium conductivity

300-600 µS/cm

high conductivity >600 µS/cm

4.To memorize setting press simultaneously the Anti-creaseand Start/Pause buttons or turn knob to Off position

23