John Lewis JLTDH15 Drying rack, Drying cycle complete / removing laundry, Open door

Drying cycle complete / removing laundry

Once the drying cycle is complete, the display shows the anti-crease icon and flashing "0" as well as warning lamps: Filter and Full tank. If the Alarm button has been pressed, an acoustic signal sounds intermittently for about one minute.

The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming.) If Anti-creasefunction has been selected, the anti-crease phase is lengthened by 60 minutes.

1.Open door.

2.Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose.

(See “Maintenance and cleaning” chapter.)

3.Remove laundry.

4.Turn the programme selector to Off.

Important! After each drying cycle:

-Clean the micro-fine filter and fine filter

-Drain the condensed water container (See chapter “Maintenance and cleaning ”.)

5.Close the door.

Drying rack

Special equipment for gentle drying washable woollens and sport shoes. Incomparable for drying wet woollens - eliminated movement, protection from matting.

For drying rack unpacking see Installation chapter.

15