Water inlet
Warning! This appliance must be
connected to a cold water
supply.
The inlet hose is screwed to the back of the
appliance.
1. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks. Always use the hose
supplied with the appliance.
Important! Do not place the inlet hose
downwards. Angle the hose to the left
or right depending on the position of
your water tap as indicated in the
picture.
35° 45°
2. Connect the water inlet hose supplied
with the machine to a tap with a 3/4"
thread. Installation should comply with
local water authority and building
regulations’ requirements.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Warning! Installation should
comply with local water
authority and building
regulations’ requirements.
The appliance must be
connected to a cold water
supply.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe
operation of the appliance.
If you cannot make the cold water
connection direct from the rising
mains, you may be able to operate the
appliance from your cold water
storage system.
There should be a minimum vertical
distance of 5.02 m (16.5 ft) between
the appliance’s inlet and the bottom of
the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system
using one of the following methods.
1. Into a drainage standpipe
24