Firstly form a hook in the end of the drain hose
using the “U” piece” supplied.
1
Place the drain hose into your standpipe,
which should have an internal diameter of
approximately 38 mm thus ensuring there is
an air break between the drain hose and
standpipe.
38 mm (½”)
30 cm (12”)
When discharging into a standpipe ensure that
the top of the standpipe is no more than 90
cm (35.4'') and no less than 60 cm (23.6'')
above floor level.
3 pin
Min. 60 cm (23.6”)
Min. 90 cm (35.4”)
The drain hose may be extended to a
maximum of 4 metres. An additional drain
hose and joining piece is available from your
local Service Force Centre. The joining piece
must have an internal diameter of 18 mm.
If your drain hose looks like this (see below)
you do not require the “U” piece”. Just push
the hose firmly in to the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before,
remove any blanking plug that may be in place.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is formed in
the drain hose (see diagram) to prevent waste
from the sink entering the appliance.
If you intend to drain the hose from the
machine into a sink, make sure that the sink is
empty and the plug hole is not blocked.
Use the plastic “U - Piece” supplied.
25