•Press 9 button again.
Cancelling the delayed start
•Press button 9.
•Press «Delay start» button once until the symbol «0’» is displayed.
•Press button 9 again.
The Delay Start cannot be selected with the draining programme.
Start the programme
To start the selected programme, press the button 9 ; the green pilot light stops flashing. If you have selected a delay time, the countdown will begin and will be shown on the display.
To interrupt a programme which is running, press button 9: the green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the button 9 again. If an incorrect option is selected, the red pilot light of button 9 flashes 3 times and the message Err is displayed for a few seconds.
Important!
You must set the washing machine to Pause before you make any change in the programme in progress.
How to change an option or a programme during its cycle
It is possible to change some options before the programme carries them out. Before you make any change, you must pause the washing machine by pressing the button 9. Changing a running programme is possible only by resetting it.
Turn the programme selector dial to «Off» and then to the new programme position. Start the new programme by pressing the
button 9. The washing water in the tub will not empty out
How to interrupt a programme
Press the button 9 to interrupt a programme which is running, the corresponding green pilot light starts blinking.
Press the same button again to restart the programme.
How to open the door during the cycle of a programme
You can open the door, after having set the washing machine to Pause, provided the following conditions exist:
•The washing machine is not in the heating phase
•The level of the water is not high;
If these requirements are met, when you pause the washing machine, the «Door lock» light goes off and the door can be opened.
Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by turning the selector dial to Off. After a few minutes, you can open the door.
Pay attention to the level and temperature of the water in the washing machine! When you close the door to restart the programme turn the dial to the previous programme and repeat the options previously selected and press button 9.
15
