4/29/03

RIP FENCE Standard all models (figure 2) (Part number 714805 – Model 24/40)

(Part number 714869 – Model 16)

Used for cutting material in accurate straight lines. To attach, insert T-bolt provided in the T-slot in the front of the table. Slide into the desired position and tighten handle.

PROFILE CUTTING ATTACHMENT Standard on VH-24 /VH-40 models (figure 3) (Part number 714821)

This device is used for cutting irregular shapes with the use of the hydraulic table. Set the chain up as shown in figure 3. Set the material in the holder and guide with the hand wheel on the right side of the table. The excess chain should be coiled out of the way, while operating the machine.

Note: When chain is not engaged in the rear sprocket the angle of cut is controlled by guiding the handles on the holder.

PROTRACTOR HEAD Standard on 24/40 models. Optional for 16 models (figure 4)

(Assembly Part number 714800

24/40 Models)

(Assembly Part number 75561

16 Models)

Used for cutting angles 90 degrees to 45 degrees in relation to the blade. It is fastened to the table by means of T-bolts. The L-shaped bar is used for additional support of the work.

T-SLOTS

T-slots are machine into the work table for your use with fixturing or other accessories. The dimensions of these T-slots are furnished to the right.

Manual V-16, V-24, VH-24, V-40 & VH-40

25 – Section I

Page 25
Image 25
Johnson Hardware VH-40, VH-24, V-24, E-16, V-40, V-16, Johnson Vertical Band Saws instruction manual Slots