Jonsered GC 2125C manual Assembly, Fitting the loop handle, Fitting the J-handle

ASSEMBLY

Fitting the loop handle

(GT 2125)

•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.

•Fit the screw, securing plate and wing nut as shown in the diagram.

•Tighten the wing nut.

Fitting the loop handle

(GC 2125, GC 2125C)

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•Fit the nut, washer and screw.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

Fitting the J-handle

(GC 2125, GC 2125C)

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•Fit the nut, knob and screw. Do not overtighten.

•Attach the J-handle to the loop handle using the three screws, as shown.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

WARNING! Only grass blades/grass cutters

!or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J-handle.

English – 11