Manuals / Jonsered / Lawn and Garden / Brush Cutter

Jonsered GC 2125C manual Two-piece shaft, Bevel gear, Maintenance

Models: GC 2125 GC 2125C

1 36

Download 36 pages 43.53 Kb

Page 25

Image 25

MAINTENANCE

Two-piece shaft

(GC 2125C)

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) on models with two-piece shafts will seize if they are not lubricated regularly.

Bevel gear

The bevel gear is ﬁlled with the right amount of grease at the factory. However, before using the machine you should check that the bevel gear is ﬁlled 3/4 full with grease. Use JONSERED special grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

English – 25

Page 25

Image 25

Jonsered GC 2125C manual Two-piece shaft, Bevel gear, Maintenance

Contents

Operator’s manual EPA Symbols KEY TO SYMBOLSContents CONTENTSNote the following before starting Dear customer INTRODUCTIONWhat is what? WHAT IS WHAT?Personal protective equipment GENERAL SAFETY PRECAUTIONSGENERAL SAFETY PRECAUTIONS Machine′s safety equipmentStop switch Throttle lockoutCutting attachment guard GENERAL SAFETY PRECAUTIONSVibration damping system MufﬂerGENERAL SAFETY PRECAUTIONS Cutting equipmentLocking nut Cutting equipmentSharpening grass cutters and grass blades GENERAL SAFETY PRECAUTIONSTrimmer head General rulesFitting the loop handle ASSEMBLYFitting the J-handle Fitting the loop handleAssembling the cutting equipment Assembling and dismantling the two-piece shaftFitting the trimmer guard and Auto 32 trimmer head ASSEMBLYASSEMBLY Fitting other guards and cutting attachmentsG F E D B AC ASSEMBLY Fitting the trimmer guard and trimmer headFit the guard as shown in the diagram. Tighten securely Hold the dust cup with a spanner to prevent the shaft from rotatingFUEL HANDLING Fuel safetyFuel FUEL HANDLING FuelingMixing Check before starting STARTING AND STOPPINGStarting and stopping Stopping STARTING AND STOPPING18 - English General working instructions WORKING TECHNIQUESWORKING TECHNIQUES Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping WORKING TECHNIQUESCarburetor MAINTENANCEMAINTENANCE MufﬂerFine adjustment of the idle speed T Correctly adjusted carburetorAir ﬁlter Cooling systemSpark plug MAINTENANCEBevel gear Two-piece shaftMAINTENANCE MAINTENANCE Maintenance scheduleTechnical data TECHNICAL DATA28 - English TECHNICAL DATAYOUR WARRANTY RIGHTS AND OBLIGATIONS FEDERAL EMISSION CONTROL WARRANTY STATEMENT6,0 m Tap-N-Go10 cm 3,05 m 15 cm15 cm Trimmy H2,4-2,7 mm 4,25 m 095-.1064,25 m 2,4-2,7mm´z+R3¶5y¨ ´z+R3¶5y¨Tap-N-Go 2,4-2,7 mm2,4 mm Auto4,0 m ~2,0 m1150271-95 ´z+R3¶5y¨ ´z+R3¶5y¨