Manuals / Jonsered / Lawn and Garden / Brush Cutter

Jonsered GC 2125C manual Fitting the trimmer guard and trimmer head, Assembly

Models: GC 2125 GC 2125C

1 36

Download 36 pages 43.53 Kb

Page 14

Image 14

ASSEMBLY

Fitting the trimmer guard and trimmer head

(GT 2125)

Guard

•Fit the guard as shown in the diagram. Tighten securely.

Trimmer head

•Fit the dust cup on the shaft. The nut must be completely covered by the dust cup.

•Hold the dust cup with a spanner to prevent the shaft from rotating.

•Screw the trimmer head onto the shaft.

14 – English

Page 14

Image 14

Jonsered GC 2125C manual Fitting the trimmer guard and trimmer head, Assembly, Screw the trimmer head onto the shaft

Contents

Operator’s manual EPA KEY TO SYMBOLS SymbolsNote the following before starting CONTENTSContents INTRODUCTION Dear customerWHAT IS WHAT? What is what?GENERAL SAFETY PRECAUTIONS Personal protective equipmentStop switch Machine′s safety equipmentGENERAL SAFETY PRECAUTIONS Throttle lockoutVibration damping system GENERAL SAFETY PRECAUTIONSCutting attachment guard MufﬂerLocking nut Cutting equipmentGENERAL SAFETY PRECAUTIONS Cutting equipmentTrimmer head GENERAL SAFETY PRECAUTIONSSharpening grass cutters and grass blades General rulesFitting the J-handle ASSEMBLYFitting the loop handle Fitting the loop handleFitting the trimmer guard and Auto 32 trimmer head Assembling and dismantling the two-piece shaftAssembling the cutting equipment ASSEMBLYG F E D B AC Fitting other guards and cutting attachmentsASSEMBLY Fit the guard as shown in the diagram. Tighten securely Fitting the trimmer guard and trimmer headASSEMBLY Hold the dust cup with a spanner to prevent the shaft from rotatingFuel Fuel safetyFUEL HANDLING Mixing FuelingFUEL HANDLING Starting and stopping STARTING AND STOPPINGCheck before starting 18 - English STARTING AND STOPPINGStopping WORKING TECHNIQUES General working instructionsGrass trimming with a trimmer head Grass clearing using a grass bladeWORKING TECHNIQUES TrimmingWORKING TECHNIQUES SweepingMAINTENANCE CarburetorFine adjustment of the idle speed T MufﬂerMAINTENANCE Correctly adjusted carburetorSpark plug Cooling systemAir ﬁlter MAINTENANCEMAINTENANCE Two-piece shaftBevel gear Maintenance schedule MAINTENANCETECHNICAL DATA Technical dataTECHNICAL DATA 28 - EnglishFEDERAL EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS10 cm 3,05 m Tap-N-Go6,0 m 15 cmTrimmy H 15 cm2,4-2,7 mm 4,25 m 095-.1064,25 m 2,4-2,7mmTap-N-Go ´z+R3¶5y¨´z+R3¶5y¨ 2,4-2,7 mm4,0 m Auto2,4 mm ~2,0 m1150271-95 ´z+R3¶5y¨ ´z+R3¶5y¨