ASSEMBLY
Assembling and dismantling the two-piece shaft
(GC 2125C)
Assembly:
•Loosen the coupling by turning the knob.
•Align the tab of the attachment (A) with the arrow on the coupling (B).
B
A
•Push the attachment into the coupling until the attachment snaps into place.
•Before using the unit, tighten the knob securely.
Dismantling:
•Loosen the coupling by turning the knob (at least 3 times).
•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.
C
Assembling the cutting equipment
WARNING!
!When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.
Fitting the trimmer guard and Auto 32 trimmer head
(GC 2125, GC 2125C)
L
K
G
KF
I 
B
J
C
I
A
•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the guard onto the fitting on the shaft and secure it with the bolt (L).
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•To fit the trimmer head, first separate the two halves (see diagram). Proceed as follows:
12 – English
