Introduction | Jonsered SM 2055 E, SM 2186 specs

INTRODUCTION

Introduction

This operator’s manual describes in detail how the one-man sawmill is used and maintained and how servicing is to be carried out. It also describes the measures to be taken for maximum safety and how the safety features are designed and function, as well as how they are inspected, maintained, and repaired if necessary.

NOTE! The section dealing with safety must be read and understood by all those who install, use, or repair the sawmill.

The operator’s manual comprises installation, usage, and the different maintenance procedures that can be performed by the operator. More comprehensive servicing or troubleshooting should be performed by the dealer’s service personnel.

The operator’s manual describes all the requisite safety features and should be read and understood by the user before the sawmill is assembled.

Symbols and warning signs shown on the next page can be found in this operator’s manual and on the one- man sawmill. If a decal on the sawmill has been damaged or is worn, a new warning decal must be applied as soon as possible in order to ensure the greatest possible safety when using the sawmill.

The one-man sawmill shall only be used to cut boards and planks from logs.

The one-man sawmill should be used outdoors and not in enclosed spaces.

English – 3

Image 3

Jonsered SM 2055 E, SM 2186 manual Introduction

Contents

SM 2186 SM 2055 E Table of Contents Introduction Introduction Symbols KEY to Symbols Safety Regulations Safety RegulationsPersonal Protective Equipment Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During Use One-man sawmill chain saw engine Description One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIG Feed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIG Electric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIG Folding Stops C Height Adjustment BRails Log Bolsters a Adjustable Support Feet Rail StopRail Guard Safety Devices Unpacking InstallationInstallation Installation Site Saw Carriage Adjustment FIG Setting up the Saw Carriage FIG One-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engine Install scale pointer and scale FIG Install the handlebar FIGInstall throttle and cable FIG Checking the bar Adjusting the bar Fuel Handling Fuel chain saw enginePetrol Two-stroke oil MixingFuelling Starting and Stopping Starting a cold chain saw engine FIGStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIG Securing the Log USE Sawing Calculating the Yield Starting the Electric Motor Starting the Petrol Engine Edging FIG Clutch drum Maintenance Saw chain Drive belt Saw unit’s height adjustment Monthly maintenance MaintenanceDaily maintenance Weekly maintenance Technical data Technical Data Noise Levels Vibration LevelsEU Declaration of Conformity only applies to Europe Page 2003W50 108 89