Jonsered SM 2186, SM 2055 E manual Two-stroke oil, Mixing, Fuelling

FUEL HANDLING

Two-stroke oil

•For the best results use JONSERED two-stroke oil, which is especially developed for chain saws. Mixing ratio 1:50 (2%).

•If JONSERED two-stroke oil is not available, you may use another two-stroke oil of good quality that is intended for air cooled engines. Contact your dealer when selecting an oil. Mixing ratio 1:33 (3%)- 1:25 (4%).

•Never use two-stroke oil intended for water cooled outboard motors, so-called, outboard oil.

•Never use oil intended for four-stroke engines.

Mixing

•Always mix the petrol and oil in a clean container intended for fuel.

•Always start by filling half the amount of the petrol to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of petrol.

•Mix (shake) the fuel mixture thoroughly before filling the saw’s fuel tank.

•Do not mix more than max. one month’s supply of fuel.

•If the saw is not used for some time the fuel tank should be emptied and cleaned.

Fuelling

1.Clean around the fuel cap.

2.Open the fuel cap slowly so that any excess pressure is released.

3.Tighten the fuel cap carefully after fuelling.

Clean the fuel tank regularly. The fuel filter should be changed at least once a year. Contamination in the fuel tanks causes malfunction. Make sure the fuel is well mixed by shaking the container before fuelling.

Gasolin		Oil • Öl
Benzin		Huile • Aceite
Essence		Lit.
Gasolina
	2%(1:50) 3%(1:33) 4%(1:25)
Lit.
5	0,10	0,15	0,20
10	0,20	0,30	0,40
15	0,30	0,45	0,60
20	0,40	0,60	0,80
US		US
gallon		fl. oz.
	2%(1:50) 3%(1:33) 4%(1:25)
1	2 1/2	3 3/4	5 1/8
2 1/2	6 1/2	9 3/4	12 7/8
5	12 7/8	19 1/4	25 3/4

22 – English