INSTALLATION
One-man sawmill with chain saw engine
Install the handlebar (FIG. 32)
The handlebar with the throttle is installed on the saw carriage using two bolts.
Install throttle and cable (FIG. 33)
The throttle and lever are installed in the chain saw’s handle. The loop (A) is positioned inside the handle. The washers (B and C) are screwed into position.
When the throttle’s mounting is installed, the throttle lock on the saw is pressed in. Connect the cable from the handlebar into the lever and adjust it using the screw nipple. When the throttle on the handlebar is not activated, the play between the throttle on the saw and the lever (D) should be approximately 1 mm.
Install scale pointer and scale (FIG. 34)
Install the scale pointer and scale as follows:
1.The scale pointer is installed using two
2.Insert the scale through the scale pointer from above. The scale’s greatest value should point downwards. Screw the scale into the saw carriage
3.Measure the distance between the lower part of the saw chain (D) and the log bolster. Set the scale pointer so that the scale has the same value.
4.Bolt on the scale pointer.
5.Check that the saw chain moves freely over the long
(E)and short (C) log supports when the red mark can be read on the scale.
FIG. 32 |
FIG. 33 |
A |
B |
C |
D |
1 mm
FIG. 34 |
E |
A |
C |
B |
D |
English – 19 |
