14.10 Empty system
This procedure is necessary to prevent your machine from frost damage while being transported.
Put a container under the pivoting nozzle (20).
Press selector key and remove water tank
STEAM INTAKE
PRESS STEAM / FILL SYSTEM
Switch off machine by pressing ON/OFF key .
15. Cleaning
The machine has an integrated cleaning program. The procedure lasts about 15 minutes.
Jura cleaning tablets which are specially designed for the cleaning program of your IMPRESSA are available at your authorized dealer. Please note that machine defects or residues in the water cannot be excluded if you use inappro- priate cleaning agents.
It is essential not to interrupt the process once it has been started.
Switch on your machine by pressing ON/OFF key
Press key until you can hear an acoustic signal.
EMPTY TRAY (FILL WATER might show as well)
Put a sufficiently large container under the
ADD TABLET (Fig. 9) / PRESS CLEANING
UNIT CLEANING / PLEASE WAIT
EMPTY TRAY
PLEASE WAIT
RINSE UNIT
COFFEE READY
The powder funnel for
16. Decalcifying
Your machine has an integrated decalcifying program. It lasts approx. 50 minutes.
Jura
Run the decalcifying program only after the machine has been switched off for at least 5 hours and has cooled down completely. The running decalcifying program must not be interrupted.
If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especi- ally natural stone and wooden surfaces, or take correspond- ing precautions.
In any case please wait until the filled decalcifying agent is used up and the tank is empty. Never top up the decalcifying agent.
Remove and empty water tank.
Replace empty water tank.
Switch off your machine by pressing ON/OFF key and let it cool down for approx. 5 hours.
18