If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions.
3. Check before use
3.1 Checking mains voltage
The machine is set for the correct voltage before leaving our factory. Ensure that your mains voltage corresponds to the details quoted on the rating plate attached to the bottom of the machine.
3.2 Checking fuse
The machine is designed for a current of 10 amps. Check that an appropriate fuse is fitted.
3.3 Adding coffee beans
To ensure that your machine will work perfectly for a long time and to avoid damage, please note that the grinding gear of your Jura coffee machine is not suitable for coffee beans which were treated, during or after roasting, with additives (e.g. sugar). Such coffee blends may damage the grinding ge- ar. Any repair costs resulting from the use of such blends are not covered by warranty.
Lift up cover of the bean container (13) and remove aroma pro- tection lid.
Clean out any dirt or foreign object from the bean container.
Fill the grinder container (Fig. 1) with coffee beans, replace aroma protection lid and close the cover.
3.4 Adjusting grinder
You can adjust the grinder to the roast of your coffee. We recom- mend the following:
for a light roast | a finer adjustment |
for a dark roast | a coarser adjustment |
Open the cover of the bean container (13).
To adjust grinding turn selector switch (Fig. 1) to the desired position.
You have the following possibilities:
the smaller the dots, the finer the grinding the bigger the dots, the coarser the grinding
The grinding grade should only be adjusted while the grinder is working.
4. Preparing machine
4.1 Fill system with water
Switch your machine on by pressing ON/OFF key 
. The machine adjusts
PLEASE WAIT
FILL SYSTEM / PRESS STEAM
Press key 
.
FILL WATER
Remove water tank and rinse well with clear
Fill water tank and replace. Make sure that tank engages well.
FILL SYSTEM / PRESS STEAM
Place a container under the pivoting nozzle (20) and press key
.
PLEASE WAIT
RINSE UNIT
8
