If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions.
3. Check before use
3.1 Checking mains voltage
The machine is set for the correct voltage before leaving our factory. Ensure that your mains voltage corresponds to the details quoted on the rating plate attached to the bottom of the machine.
3.2 Checking fuse
The machine is designed for a current of 10 amps. Check that an appropriate fuse is fitted.
3.3 Adding coffee beans
Lift up cover of the bean container (13) and remove aroma pro- tection lid.
Clean out any dirt or foreign object from the bean container.
Fill the grinder container with coffee beans, replace aroma pro- tection lid and close the cover.
3.4 Adjusting grinder
You can adjust the grinder to the roast of your coffee. We recom- mend the following:
for a light roast | a finer adjustment |
for a dark roast | a coarser adjustment |
Open the cover of the bean container (13).
To adjust grinding turn selector switch (Fig. 1) to the desired position.
You have the following possibilities:
the smaller the dots, the finer the grinding the bigger the dots, the coarser the grinding
The grinding grade should only be adjusted while the grinder is working.
4. Preparing machine
Switch your machine on by pressing ON/OFF key 
. The ma- chine adjusts
FILL WATER
Remove water tank and rinse well with clear
Fill water tank and replace. Make sure that tank engages well. (Abb. ....).
PLEASE WAIT
RINSE UNIT
Place a container under the 
.
UNIT RINSING
COFFEE READY
5. Rinsing the machine
RINSE UNIT
Place an empty cup under the
Press rinsing key 
.
If the machine has been switched off and has already cooled down it will be necessary to carry out this rinsing function when the machine is switched on again.
After switching off the machine, the rinsing sets off automa- tically.
8
