Manual Search:
This is for searching for digital channels on a single broadcast frequency. The frequency channel number (21-
68)is entered in the box at the top left of the screen and the received signal level and signal quality can be ob- served on the two bar graphs at the bottom. When OK is pressed, the TV searches that frequency and display a list of the channels found.
Hint
The bar graphs of signal quality and signal level give a good indication of whether any channels are likely to be found. If only the signal level graph shows a high value then it is likely that an analogue channel occupies that broadcast frequency. If the signal quality bar is high as well then it is a digital frequency and digital channels will probably be found.
Again, channels which duplicate those already in the channel list are ignored. However, the manual channel search will find all channels on the broadcast frequency.
When either search is finished, press the MENU button to return to normal broadcast viewing, to watch the new digital terrestrial television channels found.
Factory Settings:
To reset the TV, highlight the Factory Settings line in the menu and press OK. A warning screen is displayed
in case of accidentaloperation.
Highlight the YES button with the “
” or “
” button and press OK to erase all the channels and settings. A
message willbe displayedon the screen.
•Press the OK button to start the automatic search.
•When the automatic search has finished, the EDIT PR LIST menu appears.
Common Interface
It is required to subscribe to a pay channel company to view the pay channels of the Digital Terrestrial broad- casting.
Obtain the Conditional Access Module (CAM) and the Viewing card by subscribing to a pay channel company, then insert those to the Television using the following procedure.
1.Switch off the TV and unplug from the mains.
2.Insert the CAM, then Viewing Card to the slot that is located in the terminal cover at the
•The CAM should be correctly inserted, it is impos- sible to insert fully if reversed. The CAM or the TV ter- minal may be damaged if the CAM is forcefully inserted.
3.Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated.
•Some CAMs may require the following set up. Please set the CAM by entering the DTV menu, Common Inter- face then pressing OK button. (CAM set up menu is not displayed when it is not required.)
•To see the viewing contract information, press MENU, Select DTV and Press OK, then Select Common Inter- face and press OK.
•When no module is inserted, “No CI Module” appears.
•Refer to the module instruction manual for details of the settings.
Setting the TV
Menu System
Your TV’s analogue part has been designed with a menu system, to provide an easy manipulation of a
MAIN MENU
Press the “MENU” button. The MENU will be displayed in the middle onthescreen.
To select a
Use the “MENU” button to go back to the previous programme when the menu does not appear on the screen.
- 16 -
