10
Menu adjustment
SOURCE SELECT
PICTURE MEMORYEXT INCAMERA
ONBWNEGA
MENU/
ENTER
TEXT
MODE
BW/
COLOR
NEGA/
POSI
LIGHTS
23451

䡵Functions

The functions and settings for each adjustment item are shown below.
RED LEVEL 0
BLUE LEVEL 0
DIGITAL ZOOM x 2
JPEG FINE
LOAD CANCEL
SAVE CANCEL
Adjustment item Functions and settings Initial value
Adjusts the blue level of the camera picture.
-30 to +30 (in increments of 1 step)
Sets the maximum magnification of the digital zoom.
OFF/x2/x4
• The altered setting will become effective only when the ZOOM button is pressed.
Adjusts the red level of the camera picture.
-30 to +30 (in increments of 1 step)
Selects the settings.
DEFAULT : Returns the current conditions to the initial values (factory-set values).
Select DEFAULT and exit the menu to start operation.
USER : Changes the current settings to those stored in memory with the SAVE
function shown below. Select USER and press the MENU/ENTER button
to start operation.
CANCEL/DEFAULT/USER
Stores current settings in memory.
Select OK and press the MENU/ENTER button to store the settings in memory.
The stored settings will be applied the next time the presenter is powered up.
CANCEL/OK
Sets the compression rate of the JPEG picture captured to a personal computer via
the USB connector.
FINE : Highest picture quality, but large file size. Normally, use this mode.
NORMAL : The file size is between FINE and ECONOMY.
ECONOMY : Lower picture quality, but smaller file size.
FINE/NORMAL/ECONOMY
•When E on the rear panel MODE switch is set to 0, there will be no menu display. (refer to MODE on the rear panel on page 8).
•When the camera picture mode is SVGA or VGA, the definition of the menu display is reduced slightly.
•With the digital zoom magnification set to x4, the picture may be pixelated when the magnification is maximized. It is recom-
mended to normally use x2.
•The settings for SOURCE SELECT and FREEZE cannot be saved. When the power is supplied, SOURCE SELECT is set to
CAMERA and FREEZE is set to OFF.
•While the menu is displayed on the screen, settings for TEXT MODE, BW/COLOR, NEGA/POSI and LIGHTS cannot be
altered. To make alteration, first exit the menu display and then change the setting.

䡵Operation

The adjustment and setting of this unit can be performed
with the on-screen menu displayed by the projector or
monitor.
Press the MENU/ENTER button 1 to display the menu.
Select the adjustment item with the 䊲 button 2 and the 䊱
button 3.
Set the data with the 䊴 button 4 and the 䊳 button 5 .
When the setting is complete, press the MENU/ENTER
button to exit the menu display.