JVC BR-DV6000E instruction manual Alarm display

ON-SCREEN DISPLAY – Alarm display –

Alarm display : An alarm message is displayed at the following positions when there has been an operation error or when BR-DV6000 is not in good condition, e.g., dirty head.

A

B

3 2 K C H – 1 / 2			S P 0 0 0 m i n
	H E A D C L E A N I N G R E Q U I R E D !
		N O	D V S I G N A L
0 3 / 0 4 / 0 3			S T A N D B Y - O F F
1 1 : 2 0 : 0 0			T C R 0 2 : 0 0 : 0 0 : 0 0

●“A” display : The state of BR-DV6000 is displayed. It continues to be displayed until the error state is

corrected. This display is not affected by the setting of the display mode.

Display	Description
LOW VOLTAGE	The voltage of the DC power source is low. If the operation continues, it enters
	the Operate OFF mode.
HEAD CLEAN-	The video head is dirty. Clean it with the head-cleaning tape exclusively for BR-
ING REQUIRED!	DV6000. (☞ Page 8)
	If the head is clogged, it is detected in the PLAYBACK mode and this message
	is displayed.
OVERHEATING!	The temperature inside BR-DV6000 has exceeded the stated value.
	Disconnect the power and place it at a cool place. If this message is displayed
	again, BR-DV6000 could be defective.
	Consult your JVC-authorized service agent.

●“B” display : Messages for incorrect operation are displayed for about 3 seconds. They are displayed when the DISPLAY mode is ON or AUTO.

Display	Description
INVALID TAPE!	Data tape for PCs or DVC PRO tape is used.
	The cassette tape will be automatically ejected.
LP TAPE!	The user attempted to play back a tape recorded in the LP mode.
	BR-DV6000 cannot record or play in the LP mode.
NO DV SIGNAL	The user attempted to record without DV signal input.
COPY INHIBIT	The user attempted to record copy-guarded signals.
REC INHIBIT	The user attempted to record on a tape that is not ready for recording (the rear
	switch is set to SAVE).
REC INHIBIT	The user attempted to record analog signals when PB/DV IN in the SYSTEM
(NTSC/PAL)	(2/2) Menu is set to NTSC.

E-24