JVC BR-DV6000E instruction manual Playing back the time code, Monitor / LCD Status display

TIME CODE – Playing back the time code –

BR-DV6000 is also equipped with a time code reader. During playback, the time code or userÕs bit data recorded on the tape is displayed on the monitor or the LCD.

						OPERATE
DISP	RESET	PROFESSIONAL	A.DUB		REC	PLAY	PAUSE
SET	SEARCH+
			EJECT		REW	STOP	FF
BLANK	CUE UP
REC LEVEL					AUDIO	INPUT	REMOTE
			COUNTER MONITOR OUTPUT SELECT
			CTL	L	CH-1/2	DV
			TC	MIX	MIX	LINE
CH-1/3	CH-2/4	BR-DV6000	UB	R	CH-3/4	Y/C	LOCAL
						(CPN)

LINE	VIDEO	COMPONENT			REMOTE2
Y/C
IN		R-Y	B-Y	IN
		Y
				OUT	AUDIO
				CH 1/3		CH 2/4
OUT						IN
						OUT
MONITOR		IN		OUT
OUT			TIME CODE
		SYNC IN
			IN	OUT
				OFF
				REC	PLAY
SIGNAL		DV	SERIAL	TIMER		MONITOR
	DC12V	IN/OUT				OUT	REMOTE1
GND			REMOTE

COUNTER switch TIME CODE OUT terminal

Monitor / LCD (Status display)

3 2 K C H Ð 1 / 2			S P 0 0 0 m i n
A S S E M
	W A R N I N G		7 0 0 1
	D R U M MO T O R F A I L U R E
	R E C	I N H I B I T
0 3 / 0 4 / 0 3				P L A Y
1 1 : 2 0 : 0 0		T C R	0 2 : 0 0 : 0 0 : 0 0

Time code or userÕs bit

1. Select the time code data to display.

Set the COUNTER switch to ÒTCÓ or ÒUBÓ.

2. Press the PLAY button to go to the PLAYBACK mode.

¥It displays the time code and the userÕs bit on the monitor or the LCD. The counter display mode becomes TCR or UBR.

¥The LTC time code is output from the TIME CODE OUT terminal

on the rear panel.

❈The VITC time code is not output.

If the COUNTER switch is set to CTL, the time code is not out- put.

Caution on time code playback

●During playback, if a portion of tape without recorded time code runs through, the time code stops running. Playback continues.

●If tapes without recorded userÕs bit, e.g. those recorded with a home-use DV VCR, are played back on BR-DV6000, ÒÐ ÐÓ is dis- played.

E-63