23
English
DAILY
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
Clock
setting
(The hour digits start flashing.)
CLOCK
/TIMER
SET
/
DISPLAY
P
R
E
S
E
T
T
U
N
I
N
G
Using the Timers
There are three timers available—DAILY (Daily Timer), REC
(Recording Timer), and SLEEP (Sleep Timer).
• Before using the timers, set the clock built in the unit. (See
page 9.)

Using Daily Timer

With Daily Timer, you can wake up to your favorite music or
radio program.
• You can set the timers whether the unit is on or off.

How Daily Timer actually works

The unit automatically turns on, sets the volume level to the
preset level, and starts playing the specified source when the
on-time comes. (“DAILY” and the DAILY indicator on the
display flash just before the on-time. The DAILY indicator
continues flashing while the timer is operating.) Then, when
the off-time comes (“DAILY OFF” appears on the display
just before the off-time), the unit automatically turns off
(standby).
The Daily Timer works everyday automatically. If you do not
want to use the Daily Timer, turn it off. (See “To turn on or
off Daily Timer after it has been set” on page 24.) The timer
setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
1
again.
• To correct a misentry while setting the timer, press
CANCEL/DEMO.
Before you start...
•When using a disc as the source to play:
– Make sure there is a disc on the selected disc tray.
•When using a tape as the source to play:
– Make sure that a tape is in the cassette deck.
– Make sure that the tape direction is correct.
•When using an external component as the source to
play:
–Set the timer equipped on the external component to
the same time.
On the unit ONLY:
1

Press CLOCK/TIMER repeatedly

until “DAILY” appears on the

display.

The (Timer) indicator lights up and the DAILY (Daily
Timer) indicator also starts flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
2

Press CLOCK/TIMER again.

“TIMER” appears for about 2 seconds, then
the unit enters on-time setting mode.
3

Set the on-time you want the unit to turn on at.

1) Turn ¢ / 4 to set the hour,
then press SET/DISPLAY.
2) Turn ¢ / 4 to set the minute,
then press SET/DISPLAY.
“SET” appears for about 1
second, then the unit enters off-
time setting mode.
4

Set the off-time you want the unit to turn off

(standby) at.

1) Turn ¢ / 4 to set the hour, then press
SET/DISPLAY.
2) Turn ¢ / 4 to set the minute, then press
SET/DISPLAY.
“SET” appears for about 1 second, then the unit enters
source selecting mode.
CLOCK
/TIMER
EN21-26.HX-Z10&30[UW&UJ]1 03.3.19, 10:56 AM23