Connecting Other Equipment
You can connect an external audio component used only as a playback device.
•DO NOT connect any equipment while the power is on.
•DO NOT plug in any equipment until all connections are complete.
To connect an external audio component
Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.
English
Now, you can plug the AC power cord.
•If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.
IMPORTANT: Be sure to check that all connections are done before plugging the AC power cord into a wall outlet.
Canceling the Demonstration
When connecting the AC power cord to a wall outlet, the unit automatically starts demonstration.
To play external audio component through this unit,
connect between the audio output jacks on the other equipment and AUX jacks by using an audio cord (not supplied).
To cancel the demonstration, press and hold CANCEL/DEMO until “DEMO OFF” appears on the display.
• To cancel only beep sounds during the demonstration, press and hold BEEP for more than 2 seconds or press BEEP ON/OFF on the remote control.
The BEEP ON indicator goes off from the display.
When you press other buttons
CANCEL
/DEMO
|
|
|
| T |
|
|
|
| U |
|
|
|
| N |
/BEEP |
| I | ||
| N | |||
|
|
|
| G |
|
|
|
|
|
BEEP
ON/OFF
FADE
MUTING
Audio equipment
To audio output
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.
Voltage mark
Use a screwdriver to rotate the voltage selector so that the voltage mark is pointing at the same voltage as where you are plugging in the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.
The demonstration stops temporarily. It will start automatically again (if no operation is done for 2 minutes) unless you cancel it by pressing CANCEL/DEMO.
To start demonstration manually
Press and hold CANCEL/DEMO again until “DEMO START” appears on the display.
8
