Common Operations
Turning On or Off the Power
2 Press 4 or ¢ to adjust the hour, then press SET.
To turn on the unit, press STANDBY/ ON so that the STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the STANDBY lamp lights up.
STANDBY
STANDBY/ON
STANDBY
STANDBY/ON
ECO
ECO
SET
The minute digits start flashing on the display.
•If you want to correct the hour after pressing SET, press CANCEL/DEMO. The hour digits start flashing again.
A little power is always consumed even while the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “–
Saving the Power Consumption While on Standby—ECO mode
You can save the power consumption while the unit is turned off (on standby).
To activate the ECO mode, press ECO | STANDBY | ECO |
while the unit is turned off (on standby). | STANDBY/ON |
|
|
| |
The display illumination (including the |
|
|
display demonstration) disappears. |
|
|
To deactivate the ECO mode, press ECO again.
The display illumination appears.
About ECO mode
While ECO mode is activated, the display demonstration is canceled temporarily.
Setting the Clock
Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.
3 Press 4 or ¢ to adjust the minute, then press SET.
SET
To check the clock time
Press DISPLAY while playing any source. | DISPLAY |
|
•Each time you press the button, the source indication and the clock time alternate on the display.
To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until “CLOCK” is selected.
•Each time you press the button, the clock/timer setting modes change as follows:
DAILY ON TIME REC
(Daily Timer)
Canceled CLOCK ON TIME
(Recording Timer)
If there is a power failure
The clock loses the setting and is reset to “–
Selecting the Sources
To listen to the radio, press FM/AM. (See page 11.) To play back CDs, press CD 6. (See pages 14 – 17.) To play back tapes, press TAPE 3. (See page 18.)
To select the external equipment as the source, press AUX.
On the unit ONLY:
1 Press CLOCK/TIMER.
The hour digits start flashing on the display.
| FM | CD | |
AUX | TAPE | ||
/AM | |||
|
|
CLOCK
/TIMER
When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and starts playing the source if it is
– 9 –